MOD INSTALL : STERN STAR TREK PREM/LE : MULTI-BALL BLACK OUT MOD INSTALL
I just installed the multi-ball black out mod on my Star Trek Prem. It was really easy to install. The install time took about 10 minutes to complete. The mod turns off all the GI lighting when entering the multi-ball mode. You have an option to turn off all the lighting or reduce the lighting with a switch on the mod board.
• Remove legs from the connector on the backside of the board that connects to the lighting board on the pinball machine. I cut the legs off with a sharp scissor that is used when cutting bones during cooking. (Cooking Scissors)
• Remove connector from the GI board, plug in board to the open connector, connect connector that was removed from the board initially and plug it into the mod board that was plugged into the GI board.
• Connect wire that came with kit to the laser located near apron, run cable down to the GI board and plug the other end into the mod board where it states laser.
• Organize and tie wires together with wire ties.
Pinside Post :
Click Below to View Install Video :